Reference pages

Saturday, April 6, 2024

Trackwork Wars, Part 12

My efforts to correct a pair of troublesome switches near the outer end of my Santa Rosalia Branch layout are continuing. In the previous post on this topic, I showed the beginnings of replacement, after the offending switches had been removed and discarded. (That post can be viewed at this link: https://modelingthesp.blogspot.com/2024/04/trackwork-wars-part-11.html .) An important issue unresolved at the end of that post was the realignment of the MP1 switch machines that power these two switches.

The decision I made was to move both MP1s, but not very far. This can be best illustrated with an overhead photo, showing an intermediate step. In the photo below, the MP1 at left has been shifted leftwards, and the trench for its operating rod enlarged to the left. That permitted the MP1 at right to be moved leftwards also, and on the premise that it will operate all right at an angle to the track’s perpendicular, a new trench was cut. The old trench is the empty one at the right.

Next came fitting the curved switch that goes to the right of the photo above. This had complications, since it was too long at the throwbar end, and too short at the far end. I fixed the latter with a couple of short segments of rail (a few millimeters long), soldered into long rail joiners.

I then proceeded to fit the track together. Though this was a little demanding, given that the area I was working in is among the least conveniently accessible on the layout, I did get everything lined up and assembled. Here you see it all, prior of course to detailed testing of the work and verification that it would operate okay. Both MP1 switch machines are connected too.

I began testing with a long-wheelbase Consolidation steam locomotive, just to see what is likely to be the worst case. Loco SP 2829 worked fairly well over this new track, but inconsistently seemed to find areas of less than perfect gauge. I have continued work to try and find (and correct) these little bugs, and have steadily found and fixed a number, but am sure more needs to be done.

So it’s clear that this new pair of switches is not exactly ready for “prime time,” as we say, but probably will be all right for my upcoming operating session. To be safe, I’ll probably use a 4-axle diesel switcher on the local, just to give a little margin for remaining problems.

Tony Thompson

No comments:

Post a Comment