The peculiar Walthers steel reefer, Part 2

Previously I wrote about the numerous oddities in lettering on the new Walthers “mainline” refrigerator car model, particularly on the version pretending to be a PFE Class R-30-13 car. Since it is a steel car body, this is obviously beyond help, disappointing because the lettering is actually quite accurately rendered — for a wood car. That earlier post is here: https://modelingthesp.blogspot.com/2024/10/the-peculiar-new-walthers-steel-reefer.html . 

To make the lettering accurate, the car needs almost everything re-lettered. But let’s see what can be simply done to make the biggest improvements. To me, the easiest fix on the model is to replace the wrong UP medallion on the side (left side) with the SP emblem toward the B end, with a black and white one. For this you want Microscale set 87-501, but be sure it’s from within a few years of purchase. Microscale continues to apply original numbers to revised and improved sets, of which this is one.

Here’s what it should look like (PFE photo), a repeat from the previous post for clarity.

The repack stencil, the distinctive PFE design with pointed rectangles, just visible at the bottom of the photo above, needs to be added too, and this is in the same Microscale set. Finally, a reweigh date appropriate to your modeling era should replace the “NEW” date on the model. After January 1, 1949, the required reweigh interval was 48 months, so I have to use 1950 or later reweigh dates on my 1953 layout. Here is the re-done left side.

This simple approach can’t be repeated on the other side, the right side, however, because the SP emblem is now away from the B end. For that arrangement, typical of 1946–1948, the UP emblem would be the one without the word “railroad” in the blue field, and like the black-white emblems, these are readily available in the Microscale decal sets. For this, the desired set number is 87-414. It also contains the repack rectangles. Here is the re-done right side.

One easy detail to fix on the “R-40-10” model is the corner sill steps, which on the prototype were orange in the 1948 paint scheme; this is an easy correction. And many Class R-40-10 cars, starting in October 1950, were refurbished and upgraded, visibly receiving steel-grid running boards (like this model) and car fans. One could also apply Preco fan boxes to this model, taken from Details West set RD-215, but given all the other compromises, it doesn’t seem needed.

This leads me to comment that some might contemplate correcting the rest of the model, replacing the incorrect roof, carving off the molded-on ladders and grab irons, and replacing them with free-standing details, and so on. To me, this would be a waste of time. InterMountain makes an excellent R-40-10 model, without any of these issues, while it would be a lot of work on the Walthers body to come close. 

So “saving” this model, to me, means making it acceptable as a “main line” model, all right in a passing train but perhaps not in switching, where it could be scrutinized. I completed the work I want to do by I painting the corner sill steps orange, and the very shiny wheel faces dark gray, then giving the whole model a coat of flat finish, preparatory to weathering.  I followed my typical method, washes using acrylic tube paints, as has been described and explained in my “Reference pages” (see link at top right of this post).

In this photo, you can see that I’ve also added a few chalk marks, and a route card applied where the route card board should be, at the bolster, though Walthers has not molded that detail on this model.

That completes the paint scheme revisions I wanted to do, to at least make the paint scheme(s) of this car credible, suitable for use as a “mainline” car. The shortcomings of the car body will be ignored. I’ve gone as far as I want to with this one.

Tony Thompson