My 50-foot Erie auto car, Part 4

I began work on a kitbash of a Branchline 50-foot automobile car, adding a Viking roof and preparing to model a Chicago & North Western car. But as described in a previous post, I pivoted away from that goal and decided to model an Erie car with this roof.  (Here’s a link to that earlier post: https://modelingthesp.blogspot.com/2026/04/my-50-foot-automobile-car-part-3.html .)

I have not found a good end view of the 50-foot Erie Viking-roof cars, but there does exist a nice Magor Car Co. image of the B end of one of Erie’s 40-foot double-door cars, also with inverse Hutchins ends. This is probably an adequate guide to what the 50-foot cars with those ends would look like.

n

Continuing with model work, I added Branchline grab irons to my model’s car sides and ends, locating the end ones as shown above, and also attached the end placard boards.

For the B end brake gear, I used some Tichy parts on hand from other projects, both for the brake step and supports, and for the gear box and handwheel of the hand brake. I added a length of brass rod to represent the brake shaft. 

Completing side details are the sill steps. The sill steps that you see in the photo above are what A-Line calls a “Style B” step, and I applied those A-Line steps. All these parts installed with canopy glue. Since I planned to attach coupler box lids with screws, I made new lids to fit. The model was then ready for paint.

I chose to use Tamiya red primer (“Oxide Red,” no. 87160, a paint I have previously found to give excellent boxcar-red color. The model below rests on my “interim truck support blocks” for painting (for a description, see: https://modelingthesp.blogspot.com/2014/11/interim-truck-support-blocks.html ). A running board from Kadee will be installed later.

Next came the decision about black roof and ends. From what I gathered from Erie modelers I consulted, and learned from the late Richard Hendrickson, the common black end on Erie box cars was car cement to protect the steel end, not a paint scheme,  and was applied to cars as needed, not throughout the fleet (though some car were evidently delivered with black ends). I decided to do my model that way. 

Masking car sides with grab irons and ladders already applied can be challenging, but it’s much easier with a capable masking tape such as the fine Tamiya product. It can readily be stretched to place it where it’s needed. And since the paint already on the model is Tamiya, I thought it best to use a black color of the same maker. I chose Tamiya “Rubber Black,” TS-82, as a kind of off-black color. 

Next comes lettering and weathering. I also will need to choose a car number. I don’t have as much information as I’d like about the prototype, but it looks like the Erie cars numbered 68200–68275 are my prime candidates. I will discuss that point, and show all the finishing, in a following post

Tony Thompson